Fandom

Revoltech Wiki

Revolver Joint

14pages on
this wiki
Add New Page
Comments2 Share
Revoltech Diagram

The Revolver Joint is a unique type of ratcheting joint composed of three pieces: Two half-spheres and a pin that locks the whole ensemble into place. Both half-spheres have a standardized cylindrical peg, used to connect the different body parts of any given figure.

The friction of the joint gives the figures a wide range of motion and stability, allowing for many dynamic and varied poses.

Originally, Revoltech joints are manufactured in 6mm, 6mm double, 8mm, 8mm double, and 10mm sizes. However, Evangelion Evolution figures have joints that are sligthly smaller than those usually used.



Revolver Joint Chart

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.